Rick,

Do you guys sell the plastic pieces on the head of the cimex? You know the ones we remove to clean the machine?

on my sprint, the solution is sputtering out, I have taken it apart and can't seem to find what the problem is. I have cleaned the filter in the ball, disconnected all lines that attach to the internal parts and still, I am getting sputtering.


Ralph

Ralph,

Yes we do sell the plastic plug caps for the Cimex.

SPRINT MAINTENANCE:
The Sprint needs to be cleaned out on a regular basis.

AFTER EVERY JOB:
Empty the tank, add some fresh water to the tank (hot if possible), then squeeze the solution trigger and squirt a few ounces of water through the system.

WHEN THE JET STOPS SPRAYING AS IT SHOULD:
1. Clean out the in-line filter.
2. Add some fresh water to the tank. Remove the jet from the front of the machine. Then squeeze the solution trigger (with no jet in the machine) to clear/purge the system.
3. Take a very fine sewing needle and clean out the jet. Reinstall the jet and you're good to go.

Rick Gelinas
encapman

Thanks, Rick.. I'll call the office to order

Ralph