Did a job today. First time. Industrial warehouse. 1400 sf of office space and 300 sf of nasty nasty breakroom with, well, whatever was spilled all over. 150 minutes later clean carpet every where!!!!!! Mad because it was one of the 1st jobs i forgot my camera on and it would have been one of the best before and after pics.

Man, there is a whole lot of Cimex love going on here. I hope I can add to this soon. Gives me even more confidence going into my marketing.

I'm already impressed by the little jobs I've used the Cimex on, so can't wait to use it on big ones now.

What was your mix ratio and process?
Prespay and scrub or just go at it.

Thanks

Brad Lewis
Surface Solutions Inc

Presprayed with 12 ounces of punch to the gallon. Then Cleaned with 4 ounces to the gallon of DS. In the breakroom Same formula except when finished not all spots were gone. So added about half a bottle of Realisit spotter to my las 2 Gallons of Solution in the cimex tank and went over it all again.

For some reason I always use punsh at 8oz and then on trashed carpets I go with 8oz DS and I don't have any problems.

I'll have to play with moving punch oz's up.

We have a restaurant bar we do monthley. we use to prespray with 8oz punch go over with a CBM then 4oz DS, always looked good. One time I was out of punch, so we went with 8oz DS and max pads on cimex. Looked just as good if not better and cut my time down by an hour.

Thanks

Brad Lewis
Surface Solutions Inc

I have a Chicken wing restraunt that i do everyother month. I use Punch at 10 oz and then cimex at 8 oz. I would skip he crb step but still use the punch.