Anyone use Releasit DS for OPing and if so what are your results, compared to other OP chems you have used. And what dilution rate are you using with DS while Oping

You shouldn't have any qualms about using it.You can also mix it with Punch when needed.
Patrick

My concern is the high foaming or sudsing, has this posed a problem with anyone using as OP. Seems I read a while back that a tech had been using DS for almost everything with great results?

Have been using DS with OP for the last couple of years, with no problems. Well, one problem it cleans and stays clean too long. LOL We use DS for commercial, residential, and hand foaming upholstery. Lately though I have been using Punch(OP residential), it has a little more sizzle for the nasty carpets.

Regarding mixing, just like you would do with the Cimex 4oz/gal.

Jay

Punch is better in residential.

Joe is right, Punch is better on residential and upholstry. DS is best on commercial unless a rat nasty, then pre-spray w/punch and then run DS thru the Cimex.

I have used Releasit DS on both Resi and Commercial, it is the best choice for me. Punch on the other hand I find not as good, but not bad.

I have used it with and OP, Rotary Bonnet, Extractor and Cimex as well as a Sprint, dual brush and a Windsor single brush, all work great with the DS.

I Op and have found DS is my juice of choice. I have used others but always come back to DS. I have punch but have never really used it to give an opinion. As I have read perhaps I should try it on a couple of nasties to see how it compares to DS. I have some apartments with trashed carpets and DS does a fine job. I use DS on residential and commercial......I mix 4 oz per/gal.

I too found that Punch was more usefull as a pre spray not as a standalone. Ran out of Ds in the middle of a commercial job. Kept going with punch until my wife got there with the new bottle of DS. Had to redo the area that was punch only after i was done because it just wasnt as clean as the rest.