New to the Cimex Family Help with Tile and Grout - Printable Version +- Encapsulation carpet cleaning and commercial carpet care forum by Excellent-Supply.com & Releasit (https://forum.excellent-supply.com) +-- Forum: Forum Home (https://forum.excellent-supply.com/forumdisplay.php?fid=1) +--- Forum: GENERAL DISCUSSION (https://forum.excellent-supply.com/forumdisplay.php?fid=2) +--- Thread: New to the Cimex Family Help with Tile and Grout (/showthread.php?tid=1138)

New to the Cimex Family Help with Tile and Grout - Spike - 07-19-2014 Hi all - Can you give me some advice on how you clean tile and grout with the cimex - do you prespray and then run the cimes with the tile brushes and then use truck mount or portable or shop vac to suck up the dirty water? or do you feed the prespray through the brushes like carpet cleaning? RE: New to the Cimex Family Help with Tile and Grout - Ed E - 07-19-2014 I use Aqua Mix or Grout Devil in a hand pump sprayer. I spray it on and let it dwell. Then Cimex with tile brushes. Hand scrub the grout lines with a grout brush. Suck up the slurry with a porty. I keep hot water in the Cimex tank for further rinsing down through the brushes. Suck up again with the porty. My experience is that you have to use a hand grout brush. Cimex alone just won't cut itonthe grout. I also use a splash guard around the Cimex made from plastic garden edging. Otherwise it will splash all over the place... RE: New to the Cimex Family Help with Tile and Grout - Spike - 07-20-2014 Thats a bummer, I was hoping the brushes would get to the grout. I have a truckmount and spinner so i dont need the cimex for the tile necessarily but may help with places I dont want to bring hoses. RE: New to the Cimex Family Help with Tile and Grout - Lounge Lizards - 07-21-2014 Several options, each would depend on the level of soiling and type as well as depth. I have successfully cleaned T & G with my Cimex & brushes, and then run the grout brush along edges, corners, etc; then either vacced; up with a wet 'n dry vac;, small porty; & also even a mop & bucket. I've also used my CRB many times which also picks up the slurry at the same time.. Beauty of this is that the counter rotating brushes get right down into the grout at a better angle. Again, (in the bad old days), I've used my Gekko wand or Turbo with either my t/m or porty; to rinse/extract. This though can be fraught with danger if the grout is old and crumbly or pressure too high. Just as they say, there are many ways to skin a cat, there are also many ways to clean T & G. Offering add-on services such as grout re-coloring/replacement also puts extra $$$$ in your pocket. Speaking of this, I have gone out of T & G work in regards to color/replace due to my knees. However, I always used a little gadget called a Racatac, bear with me on this.............. This is a small bit of gear that one kneels on, it has a bike seat for your bum, and a chest support as well. It also comes with 2" or 3" wheels, mine I ordered with 3". The idea is to get onto it, then propel yourself along the grout line, applying colour or new grout as required. Since I stopped doing this line of work, and no-one wanted to buy it, it has sat dormant for some time. A few weeks back, I landed a job in a very large shoe store with massive amounts of chewing gum. Now my knees and back are nearly seventy years young, so I thought outside of the box once more. Racatac to the rescue, I was able to zoom around the store on the Racatac, treating all the gum prior to Cimexing the carpet. Store manager laughed at first, but then saw the result and the fact that I was not getting up and down on my knees all the time. There is also a small tray where I was able to keep spotter, rags and scraper, plus a screwdriver for really hard stuff. This saved my bacon.