+- Encapsulation carpet cleaning and commercial carpet care forum by Excellent-Supply.com & Releasit (https://forum.excellent-supply.com)
+-- Forum: Forum Home (https://forum.excellent-supply.com/forumdisplay.php?fid=1)
+--- Forum: GENERAL DISCUSSION (https://forum.excellent-supply.com/forumdisplay.php?fid=2)
+--- Thread: Question about the 4 steel "Rods" that go into the grommets... (/showthread.php?tid=166)
Question about the 4 steel "Rods" that go into the grommets... - Derek - 10-25-2012
on my 8 year Cimex the stock pad drivers fit fine...they never fall off when i am wheeling it around with the pad drivers off of the ground.
i put those 8 year old stock pad drivers on a newer Cimex recently and the old pad drivers will fall off when i lift the cleaning head off the carpet...especially if the heads are still spinning.
any tips on how to keep this from happening?
tx!
RE: Question about the 4 steel "Rods" that go into the grommets... - encapman - 10-25-2012
You need a new set of grommets for the old drivers.
http://www.excellent-supply.com/Replacement-Grommets-for-Cimex-Pad-Drivers-Set-of-12-Cimex-Part-3232_p_139.html
That'll get you all fixed up.
RE: Question about the 4 steel "Rods" that go into the grommets... - Derek - 10-25-2012
Ahhhh makes sense! good, these oldies are my fav.