Punch for bonnet cleaning...

[Bernd]

I have to clean two hotels. The hallways and the areas in front of the elevators. I have read that Punch is a good bonnet cleaner. Normally i would use DS2 but i am thinking of using Encap Punch with my Orbot and Micro Beast bonnets.

Would Punch be more effective then DS2 when bonnet cleaning?

[lee@deepclean.us.com]

I would recommend using Punch as a booster along with DS2 when you run into an extra dirty area.
DS2 works very well by itself.

[encapman]

Lee nailed it. When we formulated Encap-Punch we determined that it'd be a good candidate for bonnet cleaning. And it is. Yet DS2 still stands its ground. DS2 works great as a stand alone bonnet cleaner. Punch has more solvents in the formulation. Using them together in tandem insures success, even in the grungiest conditions. Or you could use either one as a standalone product. You won't be disappointed.

[GroovyJon]

Bernd,

Rick and Lee are right. Like Lee I view Punch more as a booster to DS2. For bad areas I will lightly pre-spray punch and go over it with a crb , let punch sit for about 15 mins. I will then repeat with DS2... Its works great, you may not notice a big difference with Punch at 1st,,, but after dwell time or next day you will see!
Punch and Ds2 together is like my low moisture - full restoration

[Bernd]

Thanks for all your replies! Will use DS2 and Punch as my prespray for the bad areas. Lee, when you say "Punch as a booster" do you pre spray or use some oz of Punch in the DS2 mix?

[lee@deepclean.us.com]

I use 4 oz of DS2  and 4 oz of Punch together per gallon for bad areas.  
That seems to always do the job for me when needed.

[Bernd]

I use 4 oz of DS2  and 4 oz of Punch together per gallon for bad areas.  
That seems to always do the job for me when needed.

Thanks Lee, will give it a try for really bad areas.