Encapsulation carpet cleaning and commercial carpet care forum by Excellent-Supply.com & Releasit   ›   Forum Home   ›   GENERAL DISCUSSION   ›   VCT Floor Pads

  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
VCT Floor Pads
encapman
The Encapman
*******

Joined: Apr 2012
Posts: 2,579

Thanks: 28
Given 270 thank(s) in 248 post(s)
#15
09-01-2015, 04:50 PM
That's a good question. It would be hard to say for certain what those pads are made of. We have a special formula for our FiberPlus pads. We sell enough of them that we can regulate how our pads are manufactured. We have additional binder material added to our FiberPlus pads to help them hold up to carpet cleaning. Carpet cleaning is rough on pads! With the additional binder material in the FiberPlus pads they hold up better than other similar style pads. Bulking them up with additional binder material pays off.
  Website   Find
  Reply


Messages In This Thread
VCT Floor Pads - by Bernd - 04-19-2015, 02:06 PM
RE: VCT Floor Pads - by encapman - 04-19-2015, 06:43 PM
AW: VCT Floor Pads - by Bernd - 04-19-2015, 06:50 PM
AW: RE: VCT Floor Pads - by Bernd - 04-19-2015, 07:01 PM
RE: VCT Floor Pads - by encapman - 04-19-2015, 08:12 PM
AW: RE: VCT Floor Pads - by Bernd - 04-20-2015, 07:00 AM
RE: VCT Floor Pads - by FloorCareMD - 04-21-2015, 09:16 AM
AW: RE: VCT Floor Pads - by Bernd - 04-21-2015, 12:36 PM
RE: VCT Floor Pads - by encapman - 04-21-2015, 11:52 PM
AW: RE: VCT Floor Pads - by Bernd - 04-22-2015, 01:35 AM
RE: VCT Floor Pads - by encapman - 04-22-2015, 10:11 AM
AW: VCT Floor Pads - by Bernd - 04-22-2015, 10:20 AM
RE: VCT Floor Pads - by encapman - 04-22-2015, 10:51 PM
RE: VCT Floor Pads - by encapman - 09-01-2015, 04:50 PM
AW: RE: VCT Floor Pads - by Bernd - 09-01-2015, 05:00 PM
RE: VCT Floor Pads - by encapman - 09-01-2015, 05:33 PM
AW: RE: VCT Floor Pads - by Bernd - 09-01-2015, 05:55 PM
RE: VCT Floor Pads - by encapman - 09-01-2015, 08:07 PM
RE: VCT Floor Pads - by MikeHabib - 09-01-2015, 11:23 PM
AW: RE: VCT Floor Pads - by Bernd - 09-02-2015, 02:19 AM



Users browsing this thread: 5 Guest(s)