01-04-2016, 07:41 PM
Picture putting a chain onto a bicycle. You put it onto one sprocket and then work it onto the main sprocket. Similar with the belt installation.
1. Put the belt around the center spindle first.
2. Then wrap the belt around two of the pulleys.
3. Finish up by creeping the belt onto the third pulley.
3B. That's done by gently rotating the pulley assembly.
NOTE: It is a very tight fit! So expect some resistance. But don't worry, it's intended to be tight.
CAUTION: Keep your fingers out of the way. If you get your finger between the belt and the pulley it will injure you (it's that tight).
If you have any problems give us a call at the office and we can walk you through it.
1. Put the belt around the center spindle first.
2. Then wrap the belt around two of the pulleys.
3. Finish up by creeping the belt onto the third pulley.
3B. That's done by gently rotating the pulley assembly.
NOTE: It is a very tight fit! So expect some resistance. But don't worry, it's intended to be tight.
CAUTION: Keep your fingers out of the way. If you get your finger between the belt and the pulley it will injure you (it's that tight).
If you have any problems give us a call at the office and we can walk you through it.