01-16-2016, 10:14 PM
Today I performed my first Commercial paid encap job! I was excited!
It was approximately 1200 sf of office space.
I used a Low Boy (wish I had a Vario with wheels down, it pulled a little to the right), lite hogs hair pads, battery sprayer and an air mover.
Removed rust with a rust remover then flushed with small spotter.
I presprayed with Encap-Hydrox then sprayed in front of each wet pass. I went through almost a whole gallon of Hydrox. Mixed at 8oz per gal.
I was expecting to see a "milk mustache" after going over the carpet but I didnt. In order to achieve that I would have had to spray very heavy. Doesn't that defeat the purpose of VLM?
It came out good but I thought I could do better.
I have some pics but I get a message that says they're too large.
It was approximately 1200 sf of office space.
I used a Low Boy (wish I had a Vario with wheels down, it pulled a little to the right), lite hogs hair pads, battery sprayer and an air mover.
Removed rust with a rust remover then flushed with small spotter.
I presprayed with Encap-Hydrox then sprayed in front of each wet pass. I went through almost a whole gallon of Hydrox. Mixed at 8oz per gal.
I was expecting to see a "milk mustache" after going over the carpet but I didnt. In order to achieve that I would have had to spray very heavy. Doesn't that defeat the purpose of VLM?
It came out good but I thought I could do better.
I have some pics but I get a message that says they're too large.