• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rinsing out a MicroBeast bonnet
#4
Nope that works too. This shows doing a middle of the job rinse. But like you, like to launder them.

I fin\d that it works well to keep the bonnets damp/wet after the job, and then run them through a wash cycle with a light amount of laundry soap.
Then hang them to dry (don't put them in the dryer), or just use them again the next day - still damp.
  Reply


Messages In This Thread
Rinsing out a MicroBeast bonnet - by encapman - 02-24-2016, 07:05 AM
RE: Rinsing out a MicroBeast bonnet - by Enge - 02-26-2016, 01:56 AM
RE: Rinsing out a MicroBeast bonnet - by encapman - 02-28-2016, 12:37 PM



Users browsing this thread: 1 Guest(s)