Leaking tank?

[Lounge Lizards]

I doubt that you could patch it, I've never heard of that working. The only bulletproof  option is to get a new tank. I wish there was another option, but a new tank is probably going to be the way to go. Here's a link to the new tank... http://excellent-supply.com/Replacement-...p_155.html

I concur with what Rick said.

I've had a couple of tanks welded (plastic), glued & other methods.

None were a success.

I bit the bullet & bought new ones.

I believe that this problem could be removed, IF the manufacturer would INSIST on a FULL WIDTH metal plate supporting the entire width of the solution tank.

IF it was one inch less than the width & from front to rear, this would fully support the tank with no problems & place much less stress on the solution tank on that tiny piece of supporting steel.