01-18-2017, 12:16 PM
(This post was last modified: 01-18-2017, 12:19 PM by tmiklethun.
Edit Reason: additional question
)
While I appreciate the update, I am concerned that it might be to late. I use Procyon, but will stop, since I have owned the machine. That is almost a year now.
It still seems to run fine but it is very difficult to remove the bars that release the brush heads.
Would this be part of the corrosive issues?
Was this information outlined in the original warranty?
I can see it voiding warranties going forward. I don't see how it can void warranties for past use if warranty limitation was not in effect.
I also thought this was a water tight system, why is the cleaning solution getting to the internal parts of the machine. It seems like just the moisture being in there could cause a problem?
Please advice
It still seems to run fine but it is very difficult to remove the bars that release the brush heads.
Would this be part of the corrosive issues?
Was this information outlined in the original warranty?
I can see it voiding warranties going forward. I don't see how it can void warranties for past use if warranty limitation was not in effect.
I also thought this was a water tight system, why is the cleaning solution getting to the internal parts of the machine. It seems like just the moisture being in there could cause a problem?
Please advice