02-16-2013, 02:24 AM
the Cimex head would stop spinning with the slightest bit of pressure i put on it. i replaced the thin stock cord with a Kodiak cord, didn't fix the problem (i was thinking maybe not enough power was getting to the motor through that skinny little cord.)
tonight i'd finally had enough (i don't procrastinate too much.) i've had a spare belt for the past 5 years so i finally got around to replacing the belt, VOILA! the head spins non-stop now. i should'a did that sooner! took me all of 15 minutes. followed the directions to replace it that i found somewhere on the site/forums here.
a belated thanx for the assistance a few months back Rod
tonight i'd finally had enough (i don't procrastinate too much.) i've had a spare belt for the past 5 years so i finally got around to replacing the belt, VOILA! the head spins non-stop now. i should'a did that sooner! took me all of 15 minutes. followed the directions to replace it that i found somewhere on the site/forums here.
a belated thanx for the assistance a few months back Rod