Fiber plus pad when to replace

[encapman]

Rick,
Would you measure the outer portion of the pad for this 1/4''. Just trying to make a easy protocol for techs. Thanks!

Yes, run the pads down till they're roughly 1/4" on the outer edge. It's not an exact measurement - you won't need to pull out a micrometer or anything.

In fact all you really want to do is to run the pads till they're nearly gone - being careful to avoid hitting the velcro. Try to get the highest level of wear possible before replacing them.

By the way, we sell enough pads at Excellent Supply that we were able to negotiate a proprietary formulation for our pads from the manufacturer. Our FiberPlus brand pads are produced with a special binder material added to them that helps them hold up to carpet scrubbing. This additional binder material is exclusively our formulation. That's why other pads don't hold up as well as FiberPlus pads.


P.S. FiberPlus is our trademark. It's kinda funny how many of our competitors now refer to the floor pads they sell for carpet cleaning as "Fiber" pads, or use the term "FP" in their product description. Copycats.

These are the genuine ones...