Should I or shouldn't I ??

[Cairnswun]

Decisions, decisions, why does life have to be so complicated??

I'm currently fitting out a new van, basically for encap;

I have my Cimex, Sprayborg, Oreck and Gem for all encap/O.P. work.

Plus I also have a CRB for Flotex flooring, (which I just found out my extractor also cleans well, see below).

NOW, on the extraction side, instead of a conventional spotter, I have a small porty with a 100psi pump and VERY POWERFUL vac; motor, it is manual fill and empty and holds about 5 gallons of water + 5 gallons of waste.

This will be used mainly for trashed upholstery after scrubbing with either Makita or Cyclo.

I also have a small 10" wand for this as well as the 360i for some terrible small carpet jobs (urine, Flotex, etc.


Now the problem......



I also have a t/m in the old van which I haven't hardly used in a couple of years.

I was thinking of slipping in the MasterBlend TF3500 I have into the new van, but looking at how often I need something like this??? I'm in a quandary as I feel the Sprayborg will do most anything, if not, I have the small extractor.


I would value any thoughts on this before I start cutting steel and bolting in. ;-)

Ta,

Shorty.