03-13-2013, 12:42 PM
I am fairly inexperienced with encp. I'm using a Scub3 and notice the pads are tending to develop little balls of pad material on the surface of the pad. Is this caused by inadequate amount of juice?
Fiber plus pad when to replace
|
Messages In This Thread |
Fiber plus pad when to replace - by beckel - 03-07-2013, 10:31 AM
RE: Fiber plus pad when to replace - by encapman - 03-07-2013, 11:04 AM
RE: Fiber plus pad when to replace - by beckel - 03-07-2013, 11:23 AM
RE: Fiber plus pad when to replace - by encapman - 03-08-2013, 07:36 AM
RE: Fiber plus pad when to replace - by Cairnswun - 03-08-2013, 06:02 AM
RE: Fiber plus pad when to replace - by Shane - 03-13-2013, 12:42 PM
RE: Fiber plus pad when to replace - by encapman - 03-13-2013, 12:44 PM
RE: Fiber plus pad when to replace - by Cairnswun - 03-13-2013, 05:15 PM
|