03-25-2013, 09:50 PM
(This post was last modified: 03-25-2013, 09:54 PM by FloorCareMD.)
i think that supplying both end with no cap would be better, especially with the curved pipe
once the pad is wetted the supply from the manifold should keep it wet and streak free. Or the use of a little bit larger pad (say an inch) with the drips landing on the exposed pad edge might be the trick.
sort of like your photo shows...
by the way, awesome looking machine you have there
once the pad is wetted the supply from the manifold should keep it wet and streak free. Or the use of a little bit larger pad (say an inch) with the drips landing on the exposed pad edge might be the trick.
sort of like your photo shows...
by the way, awesome looking machine you have there