(08-05-2012, 12:46 PM)Mark Shannon Wrote: However my only gripe is getting a consistent feed and even distribution of encap, find I am often putting to much down in some areas.hi. as to your comments above, finding the right amount of solution and finding the right amount of flow will take time. for me i pretty much just tap - i never hold the trigger down for any longer than the 1st 4-5 seconds i turn the machine on, to get the solution to the pads as soon as possible, to give them some lubrication, so that i can set the machine down. for everything else i tap the trigger on all wet passes. give it time, you'll figure it out. and i have never touched the ball valve setting. it is wide open...that's just me though, others have.
Setting chemical feed to 7 o'clock. Is it better to pre-spray the encap down? Would prefer to use machines delivery system.
Mark
but putting too much down is never good. spots will more than likely wick back.