07-23-2013, 08:51 AM
I've now installed an inline tap in the solution hose near the inlet to my Taski 165 and with either a feathering action, or on for a couple of seconds and then off, I've started to master the shower feed method.
The tap is set to almost fully open and is handy to be able to close when needed to avoid any leaks etc.
The results I'm getting are so much of an improvement on the pre-spray method used previously.
My only question now is how much solution should I be using per m2?
I'm thinking that about 1.5 lt per average size vacant bedroom is ideal, but anymore than about 2 lt may overwet the carpet and also delay drying times?
Cammo
The tap is set to almost fully open and is handy to be able to close when needed to avoid any leaks etc.
The results I'm getting are so much of an improvement on the pre-spray method used previously.
My only question now is how much solution should I be using per m2?
I'm thinking that about 1.5 lt per average size vacant bedroom is ideal, but anymore than about 2 lt may overwet the carpet and also delay drying times?
Cammo