Encapsulation carpet cleaning and commercial carpet care forum by Excellent-Supply.com & Releasit   ›   Forum Home   ›   GENERAL DISCUSSION   ›   Removing Drive Plate from an Orbot

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Removing Drive Plate from an Orbot
Jamie
ENCAP MASTER
****

Joined: Jun 2012
Posts: 143

Thanks: 0
Given 1 thank(s) in 1 post(s)
#5
08-03-2013, 08:56 PM
Thanks Lee, appreciate it. Didn't want to go pulling it apart before consulting the "Brains Trust" on the board.

Great set-up Mike. Cheers for the pic. What sort of OP is that? Have you used an OP with spray system prior to setting up your tank? If so, what's your thoughts on both systems. I haven't tried a spray system but I like the idea of the tank more. The tank certainly made a huge difference to my rotary and the results I'm getting out of it so I assume the same would be true of the OP.

Cheers

Jamie
  Find
  Reply


Messages In This Thread
Removing Drive Plate from an Orbot - by Jamie - 08-02-2013, 06:55 PM
Removing Drive Plate from an Orbot - by MikeB - 08-02-2013, 09:43 PM
RE: Removing Drive Plate from an Orbot - by Jamie - 08-03-2013, 08:56 PM
Removing Drive Plate from an Orbot - by MikeB - 08-10-2013, 09:49 AM
RE: Removing Drive Plate from an Orbot - by Jamie - 08-10-2013, 07:53 PM
RE: Removing Drive Plate from an Orbot - by Jamie - 08-20-2013, 03:37 AM
Removing Drive Plate from an Orbot - by MikeB - 08-20-2013, 07:55 AM
RE: Removing Drive Plate from an Orbot - by Jamie - 08-21-2013, 04:14 AM
RE: Removing Drive Plate from an Orbot - by MikeB - 08-21-2013, 11:55 AM



Users browsing this thread: 1 Guest(s)