08-20-2013, 03:37 AM
So I finally took off my pad driver. Can anyone tell me if the pad driver set up in my pics are the exact same as an Orbot. One of the reasons is that I am interested in using the brush driver for T&G and need to know if it will fit.
I am still very interested in putting a solution tank on this machine. I really think it could kick butt. Any suggestions on ways to do this would be greatly appreciated. There are obviously no solution holes in the drive plate.
@ MikeB how does the internals of this set up compare to yours and how you set up the Solution feed.
Cheers Gents
This pic is once the Velcro plate is removed.
![[Image: null_zps107aee9c.jpg]](http://i1053.photobucket.com/albums/s480/ATeamCC/null_zps107aee9c.jpg)
This pic is my pad driver plate
![[Image: null_zps51c7ddc1.jpg]](http://i1053.photobucket.com/albums/s480/ATeamCC/null_zps51c7ddc1.jpg)
This pic is the insides once the pad driver plate has been removed
![[Image: null_zps0a31add3.jpg]](http://i1053.photobucket.com/albums/s480/ATeamCC/null_zps0a31add3.jpg)
I am still very interested in putting a solution tank on this machine. I really think it could kick butt. Any suggestions on ways to do this would be greatly appreciated. There are obviously no solution holes in the drive plate.
@ MikeB how does the internals of this set up compare to yours and how you set up the Solution feed.
Cheers Gents
This pic is once the Velcro plate is removed.
This pic is my pad driver plate
This pic is the insides once the pad driver plate has been removed