08-20-2013, 07:55 AM
Jamie, it looks like your drive plate bolts directly to the counter weight assembly. Mine slips over a center hub that is bolted / screwed to the counter weight
It doesn't matter though. You should be able to drill a hole in the deck of the machine and run a hose from your solution tank into it. You can just drill the hole slightly smaller than the outside diameter of the hose and push it in tight
You could drill holes in the drive plate too for better solution passage thru the plate but it didn't and it works fine.
Mine does fling shampoo around a bit though, so drilling some holes in the drive plate while its off might be the way to go. That might help keep solution from flinging out.
I used the Wave tank from Excellent Supply but its designed for a floor buffer type handle so you might want to find one that bolts up to your style handle.
It doesn't matter though. You should be able to drill a hole in the deck of the machine and run a hose from your solution tank into it. You can just drill the hole slightly smaller than the outside diameter of the hose and push it in tight
You could drill holes in the drive plate too for better solution passage thru the plate but it didn't and it works fine.
Mine does fling shampoo around a bit though, so drilling some holes in the drive plate while its off might be the way to go. That might help keep solution from flinging out.
I used the Wave tank from Excellent Supply but its designed for a floor buffer type handle so you might want to find one that bolts up to your style handle.