• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Not much luck getting into commercial cleaning... hwe? Encap? What can I do?
#11
Eric- When you say the key is to get the heavy grease loads out first, do you use a porty, then go back over with a Cimex/OP? Are you using Punch as a pre-treater/first pass with HWE (if you are using HWE)?
Ed Elliott

  Reply


Messages In This Thread
RE: Not much luck getting into commercial cleaning... hwe? Encap? What can I do? - by Ed E - 09-19-2013, 06:35 AM



Users browsing this thread: 2 Guest(s)