10-05-2013, 03:50 PM
Depends on how dirty the bad spot was. If you ever see encap
starting to turn to mud you will need to flush the carpet for sure.
Every few months HWE the carpet to get an overload of dirt out.
For most carpets the D/S2 will work good. Just mix according to the jug
and apply evenly with just the right amount. You should never run
anything thru your extractor except hot water. Unless in the future
you want to buy a new pump. You can run Punch with your cimex
but don't look for a lot of foam cause it comes out much
lighter. Then HWE it. Most commercial you should be able to use
d/s2 in your cimex. Couple of months ago I used Punch in my 175
on a filthy commercial in a bedroom and it turned to mud. So had to use HWE
to get rid of it. This place was a dump anyway with bugs dead mice cockroaches.
Welfare services paid the bill. I should have cleaned with a gal of gas & a match
which would have really helped out the renters. :-)
starting to turn to mud you will need to flush the carpet for sure.
Every few months HWE the carpet to get an overload of dirt out.
For most carpets the D/S2 will work good. Just mix according to the jug
and apply evenly with just the right amount. You should never run
anything thru your extractor except hot water. Unless in the future
you want to buy a new pump. You can run Punch with your cimex
but don't look for a lot of foam cause it comes out much
lighter. Then HWE it. Most commercial you should be able to use
d/s2 in your cimex. Couple of months ago I used Punch in my 175
on a filthy commercial in a bedroom and it turned to mud. So had to use HWE
to get rid of it. This place was a dump anyway with bugs dead mice cockroaches.
Welfare services paid the bill. I should have cleaned with a gal of gas & a match
which would have really helped out the renters. :-)