Encapsulation carpet cleaning and commercial carpet care forum by Excellent-Supply.com & Releasit   ›   Forum Home   ›   GENERAL DISCUSSION   ›   Orbot/Sprayborg questions

  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Orbot/Sprayborg questions
encaprodney
Encap Tech
***

Joined: Jul 2012
Posts: 85

Thanks: 0
Given 12 thank(s) in 11 post(s)
#6
10-23-2013, 10:22 AM
There is a switch and wire harness for the switch that can get overheated on the handle of that machine. I've seen it happen on both sides of the handle on that machine. All that current going thru the switch and harness can, over time, cause it to start melting and heating.
Rod Clarkin
Excellent Supply 727-821-2020 
  Find
  Reply


Messages In This Thread
Orbot/Sprayborg questions - by FloorCareMD - 10-22-2013, 12:34 PM
RE: Orbot/Sprayborg questions - by Shorty - 10-22-2013, 10:50 PM
RE: Orbot/Sprayborg questions - by encapman - 10-23-2013, 06:23 AM
RE: Orbot/Sprayborg questions - by encaprodney - 10-23-2013, 10:22 AM
RE: Orbot/Sprayborg questions - by FloorCareMD - 10-23-2013, 12:08 PM
RE: Orbot/Sprayborg questions - by TigerJ - 10-23-2013, 02:45 PM
RE: Orbot/Sprayborg questions - by FloorCareMD - 10-24-2013, 02:08 PM
RE: Orbot/Sprayborg questions - by NJP - 10-24-2013, 07:11 PM
RE: Orbot/Sprayborg questions - by FloorCareMD - 10-24-2013, 09:54 PM
RE: Orbot/Sprayborg questions - by encaprodney - 10-25-2013, 04:26 PM
RE: Orbot/Sprayborg questions - by FloorCareMD - 11-06-2013, 04:04 PM
RE: Orbot/Sprayborg questions - by encapman - 11-06-2013, 05:08 PM
RE: Orbot/Sprayborg questions - by FloorCareMD - 11-06-2013, 09:24 PM



Users browsing this thread: 4 Guest(s)