• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Orbot/Sprayborg questions
#9
From my experience the MF pads have a life of about 6 months to a year depending on how often you use them. They will eventually wear out and the middle will give. When this happens it's almost impossible to run the pads under a machine. MF pads are a must have of course, just don't plan on using the same pad forever.

As far as cleaning goes, since they do have a limited shelf life I don't think tossing them in a dryer will do much damage. In fact, I put Zorbs in the dryer as well. I do use a low heat dry though and haven't noticed any problems.

(10-23-2013, 02:45 PM)TigerJ Wrote: I always put my microfiber (both looped and thin with scrubbing lines) into the dryer...is there a reason for not doing this ? I never use softner sheets because I heard they affect the bonnets ability to absorb.
  Reply


Messages In This Thread
Orbot/Sprayborg questions - by FloorCareMD - 10-22-2013, 12:34 PM
RE: Orbot/Sprayborg questions - by Shorty - 10-22-2013, 10:50 PM
RE: Orbot/Sprayborg questions - by encapman - 10-23-2013, 06:23 AM
RE: Orbot/Sprayborg questions - by encaprodney - 10-23-2013, 10:22 AM
RE: Orbot/Sprayborg questions - by FloorCareMD - 10-23-2013, 12:08 PM
RE: Orbot/Sprayborg questions - by TigerJ - 10-23-2013, 02:45 PM
RE: Orbot/Sprayborg questions - by TheCleaningDude - 10-24-2013, 03:04 AM
RE: Orbot/Sprayborg questions - by FloorCareMD - 10-24-2013, 02:08 PM
RE: Orbot/Sprayborg questions - by NJP - 10-24-2013, 07:11 PM
RE: Orbot/Sprayborg questions - by FloorCareMD - 10-24-2013, 09:54 PM
RE: Orbot/Sprayborg questions - by encaprodney - 10-25-2013, 04:26 PM
RE: Orbot/Sprayborg questions - by FloorCareMD - 11-06-2013, 04:04 PM
RE: Orbot/Sprayborg questions - by encapman - 11-06-2013, 05:08 PM
RE: Orbot/Sprayborg questions - by FloorCareMD - 11-06-2013, 09:24 PM



Users browsing this thread: 3 Guest(s)