• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Vapor (steam) machine
#8
If you stand up and try to use the 'wand' motion with tile and grout, yes its slow.

You have to be willing to get to your knees and scoot around on pads, which is actually much faster for focusing on the grout lines and much easier on your back than stooping over.

The extender poles are just for steam mopping from the standing position.

You'll build speed as you refine technique.

Even for incorrigible truckmount/porty junkies, the vapor steamer can perform all the 'cut in' and small, hard to reach areas headache free, before you XS the open areas.
  Reply


Messages In This Thread
Vapor (steam) machine - by jtmellon - 01-24-2014, 08:23 AM
RE: Vapor (steam) machine - by Hoss - 01-24-2014, 09:37 AM
RE: Vapor (steam) machine - by drytouch - 01-24-2014, 06:55 PM
RE: Vapor (steam) machine - by jtmellon - 01-25-2014, 12:05 PM
RE: Vapor (steam) machine - by NJP - 01-25-2014, 12:10 PM
RE: Vapor (steam) machine - by DON ELDRED - 01-25-2014, 12:24 PM
RE: Vapor (steam) machine - by Hoss - 01-25-2014, 12:54 PM
RE: Vapor (steam) machine - by drytouch - 01-25-2014, 09:21 PM
RE: Vapor (steam) machine - by TroyD - 01-26-2014, 01:36 PM
RE: Vapor (steam) machine - by KennyWright - 01-26-2014, 06:21 PM
RE: Vapor (steam) machine - by jtmellon - 01-28-2014, 08:13 PM
RE: Vapor (steam) machine - by Ed E - 01-28-2014, 11:30 PM



Users browsing this thread: 5 Guest(s)