2014 dodge cv tradesman

[Shorty]

Ed,
I stand both my Cimex and my Orbot up in the back of my van.

The Cimex, I have the handle straight up prior to pushing up the ramps and then sit it straight onto the floor where it belongs.

The Sprayborg is a different matter at the handle is so much higher and because they are both located at the rear door, I can't move it the same way.

This is easily solved my adjusting the handle down several notches, rolling it in and then standing the handle straight up.

Bearing in mind that where the rear door is, is several inches lower than the roof lining.

Problem solved.

If the handle is still too high for the van you are looking at, keep the handle at a lower level when putting into the van and position it where you want it.

Then undo the latches that keep the handle straight and fold the handle in half, then stand the handle upright again, keeping the handle folded.



If the Cimex is also too high, you may also have to adjust the handle down to below roof level for transporting it, but the more the handle is lowered, the longer the space is needed for it to fit in.

Hope this helps.

Short 1