10-23-2012, 08:07 AM
Used the tank on my Taski scrubber yesterday and although the carpet looked great when finished (but still damp), I was having problems obtaining a consistent flow of my encap solution.
I returned to the job for a look this morning as I had a feeling it may not look as good when dry. Sure enough, there are numerous streaky areas where it appears insufficient solution was being spread, although I used about the quantity I expected. The lighter coloured areas are what I believe are cleaned areas, whereas the darker areas are insufficiently cleaned.
Until I get the tank to dispense evenly, I was thinking of going back to the job using my manual pump up sprayer (which I don't normally have any problems with) and encapping again. Will this even out the streaks?
I took a photo with my phone camera, so it's not that flash, but good enough to get the idea. Will upload if necessary and when I work out how to.
Cammo
I returned to the job for a look this morning as I had a feeling it may not look as good when dry. Sure enough, there are numerous streaky areas where it appears insufficient solution was being spread, although I used about the quantity I expected. The lighter coloured areas are what I believe are cleaned areas, whereas the darker areas are insufficiently cleaned.
Until I get the tank to dispense evenly, I was thinking of going back to the job using my manual pump up sprayer (which I don't normally have any problems with) and encapping again. Will this even out the streaks?
I took a photo with my phone camera, so it's not that flash, but good enough to get the idea. Will upload if necessary and when I work out how to.
Cammo