encap Uph cleaning

[Shorty]

I've been using the Makita variable Speed Polisher, same model as you, for several years.

I found the same as Drytouch when using the pads, they sling solution everywhere.

I use 8" bonnets, some with the blue stripe, some without, I actually have three different types.

I also use mattress covers as drop sheets.

Lay a three seat sofa on it's back, place two mattress covers underneath, and bunched up a bit against the rear.

Lower the sofa to the floor, lift the rear and pull the mattress covers out the back.

This will give you plenty of floor cover all around.

When cleaning, tilt the sofa forward and clean the back whilst on an angle.

Also do the sides at this time.

Lean the sofa at 45 degree to the back and place a small stool under the front.

This will allow you to clean the inside back, front kick panel & front arm uprights without bending too much.

Remove the stool and do the arm rests and bench seat cushions.

The use of skidders and a small jack ( one that works on a lever & fulcrum method works well ), will make this so much easier.

I now carry two x four foot collapsible/folding waterproof tables with legs that can be set at three different heights.

2 x 2 when folded.

As these are four foot long, I can easily place a chaise cushion on there and clean it.

I also use an OmniPro battery sprayer for applying solution.

Why two tables ??

When we do in excess of fifty chairs, etc; or like this week, at one job we have 2 x 3, + 4 x 1 leather chairs to do.

So both Del & I can have a table each & (with fabric) share the OmniPro between us.

With the leather, we will do a three seat sofa each & 2 armchairs, then have a table each to work on the loose cushions.

Hope this makes sense.

Short 1