10-26-2012, 07:20 PM
I presume you're using a Taski also. Do you use a brush or pad and are they pre-sprayed so as not to commence dry on a dry carpet?
I have also plugged the 80mm hole on the drive pad to avoid all the solution going straight down in one spot only. Whether this is the answer I don't know but it did seem to help. It then is distributed via the other small holes outside of the centre hole.
It just seems that if I leave the trigger open for any length of time, too much solution is being dispensed and then it sprays outside the pad as a foam and is flicked around.
I've tried to find a video of the tank being used, but the only one close showed a massive amount of foam being left on a carpet and the operator then raked it all up. Surely this is not the correct method.
Cammo
I have also plugged the 80mm hole on the drive pad to avoid all the solution going straight down in one spot only. Whether this is the answer I don't know but it did seem to help. It then is distributed via the other small holes outside of the centre hole.
It just seems that if I leave the trigger open for any length of time, too much solution is being dispensed and then it sprays outside the pad as a foam and is flicked around.
I've tried to find a video of the tank being used, but the only one close showed a massive amount of foam being left on a carpet and the operator then raked it all up. Surely this is not the correct method.
Cammo