06-07-2014, 03:37 PM
(This post was last modified: 06-07-2014, 03:38 PM by Lounge Lizards.)
Had to clean & apply protector to a lounge suite on Saturday, then clean a small rug.
After that I had a twelve hour commercial job to do, a regular customer.
Just finished the rug & stood the handle upright............... & SNAP !!!!!!!!!!!
The height adjustment rod at the rear of the solution tank/handle, snapped at the base where it screws into the ferrous piece that goes around the axle.
You think it wasn't half awkward getting Big Yella back into the van again.
So I cancelled my next job, no problem 'cept; this is a long weekend, Monday public holiday.
Short week next week.
Poor old Big Yella's gonna have a week or more off the road by the time parts arrive from down south, providing they have them in stock.
Rant over, I may even buy another one ( Mex; ), to keep as a spare. ;-)
Lounge Lizard out........
After that I had a twelve hour commercial job to do, a regular customer.
Just finished the rug & stood the handle upright............... & SNAP !!!!!!!!!!!
The height adjustment rod at the rear of the solution tank/handle, snapped at the base where it screws into the ferrous piece that goes around the axle.
You think it wasn't half awkward getting Big Yella back into the van again.
So I cancelled my next job, no problem 'cept; this is a long weekend, Monday public holiday.
Short week next week.
Poor old Big Yella's gonna have a week or more off the road by the time parts arrive from down south, providing they have them in stock.
Rant over, I may even buy another one ( Mex; ), to keep as a spare. ;-)
Lounge Lizard out........