07-07-2014, 09:19 PM
So I did my first residential low moisture cleaning with the Orbot, ds2, and Micoglide bonnets. The basement carpet cleaned up well with no real issues (dense carpet-more fibers per square inch- glided better over fiber), but the carpet upstairs which was more of a frisey style (less fibers per square inch-a bit more drag) seemed to have some fiber separation. I applied releasit via the sprayborg as i was going. here was my process...
#1. prevac
#2. Mix ds according to instructions.
#3. Place dry microglide pad on orbot.
#4. Flip orbot head down.
#5. Trigger solution spray and wet down fiber just in front on the orbot.
#6. Place orbot with dry pad on wet sprayed area and turn on.
#7. Complete cleaning passes triggering forward infront of the machine as i clean.
#8. Return to starting position with no trigger.
#9. Move to next row. Repeat
Cleaned a total of 600 sq ft. Used 2.5 orbot jugs of cleaning product.
What if anything did i do wrong here get the fiber seperation? And what other sugguestions might you guys have based on what ive written
#1. prevac
#2. Mix ds according to instructions.
#3. Place dry microglide pad on orbot.
#4. Flip orbot head down.
#5. Trigger solution spray and wet down fiber just in front on the orbot.
#6. Place orbot with dry pad on wet sprayed area and turn on.
#7. Complete cleaning passes triggering forward infront of the machine as i clean.
#8. Return to starting position with no trigger.
#9. Move to next row. Repeat
Cleaned a total of 600 sq ft. Used 2.5 orbot jugs of cleaning product.
What if anything did i do wrong here get the fiber seperation? And what other sugguestions might you guys have based on what ive written