07-14-2014, 10:26 PM
good info, thanx Stephen 
my advice below in bold text, others will have differing advice.
my advice below in bold text, others will have differing advice.
(07-14-2014, 06:23 PM)msc1917 Wrote: Q#1. Should I pre-spray my solution with a battery sprayer before and let dwell or just use my orbot and apply as I clean, or should I be doing some sort of a combination of the two? yes give dwell time when OP'ing with the Orbot, it will give superior results...10 minutes works, use your smart phones timer.
Q#2. How wet should my bonnets be - just damp as in spray some encapp on them before using them or should I downright soak them and wring them out before using them? i dont use microfiber, so idk about this one for you. but for the cotton blend pads that i use, which are similar to the Superzorbs, i downright soak them and wring them out some, so that they are still dripping wet
Q#3. Should I be following up my initial work-in of the product with a pass that is not applying solution? If so should I be using a separate bonnet, if so should that bonnet be wet or dry. no need, just vac / prespray with dwell time / OP with wet pads
Another ( I would LOVE it if you guys shared this) equally helpful way of answering this - would be to share your process for light, medium, and trashed residential carpets. If I could just get a baseline to use I feel I could find my way. As a 15 year HWE guy, I'm great at what I do - but I feel downright lost with residential low-moisture and I so want to figure this out. Thank you guys for your patience with my questions!
i use those steps for all carpet, light to heavy soil
-Stephen M