I cleaned some commercial carpet early this morning, and it just did not turn out. The carpet itself wasn't overly dirty, they had new carpet put in about a year ago. All the coffee/soda stains are gone, but the carpet is super blotchy...some patches of dark areas, some patches of light colored areas....
I mixed DS2 at 4oz gallon, put into Cimex equipped with new fiber plus pads and ran the machine with one wet pass with the trigger open moving at a moderately fast pace, followed by a dry pass moving at a slow pace, occasionally feathering the trigger. I overlapped each pass by maybe 20-30% and pre-vacuumed and post-vacummed 12 hours apart. The post-vacumming improved the blotchiness a little bit, but theres still dark places and light places all over the carpet. Any ideas what I did wrong?
I mixed DS2 at 4oz gallon, put into Cimex equipped with new fiber plus pads and ran the machine with one wet pass with the trigger open moving at a moderately fast pace, followed by a dry pass moving at a slow pace, occasionally feathering the trigger. I overlapped each pass by maybe 20-30% and pre-vacuumed and post-vacummed 12 hours apart. The post-vacumming improved the blotchiness a little bit, but theres still dark places and light places all over the carpet. Any ideas what I did wrong?