08-02-2013, 06:55 PM
This may be a silly question but here goes.
How do you remove the drive plate off an Orbot? I am toying with the idea of retro-fitting a solution tank.
I may even look into adding some solution guides on the top of the drive plate to help guide the solution into any holes I drill through so that the solution does not flick out the sides.
Has anyone else looked into retro-fitting a tank?
But with that being said I first need to get the drive plate off. Anyone know how?
My OP is not an Orbot but it was made in the USA and it looks to me to have the same driver plate set up as the Orbot. Here's a pic. Any assistance would be greatly appreciated.
Cheers Gents
Jamie
![[Image: e110003e186f437b1e561b18c6b6f14b_zpsb2cb9d2d.jpg]](http://i1053.photobucket.com/albums/s480/ATeamCC/e110003e186f437b1e561b18c6b6f14b_zpsb2cb9d2d.jpg)
How do you remove the drive plate off an Orbot? I am toying with the idea of retro-fitting a solution tank.
I may even look into adding some solution guides on the top of the drive plate to help guide the solution into any holes I drill through so that the solution does not flick out the sides.
Has anyone else looked into retro-fitting a tank?
But with that being said I first need to get the drive plate off. Anyone know how?
My OP is not an Orbot but it was made in the USA and it looks to me to have the same driver plate set up as the Orbot. Here's a pic. Any assistance would be greatly appreciated.
Cheers Gents
Jamie