Thanks: 5
Given 4 thank(s) in 4 post(s)
Ok I am going back to do a redo on a rental property that has two very bad traffic area''s. One in front of the sofa and the other from the kitchen to the back sliding glass door. With one gallon of Punch at 12 ounces , how much would you apply ?. Do you guy's use a bucket heater when using Punch as a pre -spray ?
Thanks: 28
Given 270 thank(s) in 248 post(s)
A couple of questions Mike?
1. Do you happen to have any Encap-Cleqan DS2 too?
2. Which scrubber are you planing to use?
Thanks: 5
Given 4 thank(s) in 4 post(s)
Hi Rick ,
I was going to go behind it with my VonSchrader. I have a duel speed 175/300. I do not have any DS2 yet.
Thanks: 28
Given 270 thank(s) in 248 post(s)
The VonSchrader and also a rotary should be used with a shampoo type product like Encap-Clean DS2.
1. Pre-spray with Encap-Clean DS2 at max dilution.
2. And then scrub with your VonSchrader or with your rotary machine (with FiberPlus pads) at about 6 oz per gal of Encap-Clean DS2.
3. Make additional dry passes over the heavily soiled areas.
*Optional: You could also post-bonnet with the Microbeast or Microglide bonnets to pull off some additional soil.
Those steps should produce some pretty impressive results!
