• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pizza shop
#1
Pre-sprayed with Punch. Dwelled 10 minutes. Cimex with the gray pads and Releasit, then extracted up the mud from this cruddy carpet with hot water rinse ( pizza shop does VERY well )
Photo shows before extraction/rinse. We normally do not rinse with extractor, but this carpet was dirtier than the Madden's Raiders.
[Image: 20131211_215728_zpsdebee6cc.jpg]
  Reply
#2
Amazing work!

How are you liking the Powr Flite portable?
  Reply
#3
It is OK, especially since I upgraded it to on-board heater; 220 psi pump (from 100). Want to improve the 2 vac motors next.
Here is some shots of the heater I installed. It was one of those Powerflite boxed ones. Removed from box and bolted it underneath.
[Image: Photo0269_zps98432cff.jpg]
Also installed a little radiator underneath that captures the vacuum exhaust heat too.
[Image: Photo0266_zpsd4d7c724.jpg]
covered it with a modified (fancy for "bent") old license plate.
[Image: Photo0272_zpsdfa9c400.jpg]
  Reply
#4
That's awesome. Are you running the machine off of two cords or can you squeeze it all on to a single line?
  Reply
#5
two.
one for the heater.
[Image: Photo0270_zps9e558442.jpg]
  Reply
#6
Damon, I emailed you but wasn't sure I have the correct address.
  Reply




Users browsing this thread: 1 Guest(s)