Wheels on cimex

[Prestige1]

How do you take wheels off cimex

[Lounge Lizards]

There are probably easier ways, but I use two chisel screwdrivers & a hammer.

Put one on either side of the axle & GENTLY tap each one down.

Just a bit at a time on each side.

When the drivers are down far enough, the cap can be levered off.

Hope this helps.

[encapman]

The hubcap needs to be pried off. The prying will most likely wreck the hubcap.

[Lounge Lizards]

 Rick, would you believe that I'm still on my original hubcaps despite changing wheels three times, plus an axle.

Big Yella must be getting onto about eleven now I think.

Sure, they look a bit battered and not real flash, but no-one has yet commented on them.

Bet they're afraid I'll cap 'em if they do  

[encapman]

That's pretty cool that you managed to pry off the hubcap without making them wonky. You're special Shorty. 

[Lounge Lizards]

Gonna sell my van, buy a bus & call it Shorty's Special Bus.

Then I'll attend all the trade shows giving free lifts to all the Special cleaners attending the events.

VLM ONLY ?

[encapman]

You could call it Shorty's Short Bus...

[EncapBrian]

Large pair of Channel Locks is the answer, its very easy.

[NJP]

That is so cool!!!!!! Hey Shorty, is that your ride?

[FloorCareMD]

paint can opener tool.