• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gum and more,
#1
Whats is the method that Rick uses for gum?

I already did the Cimexing job and want to go back and hit some bad spots, but I am not going to take the machine again. I am thinking I can do it by hand.


Maybe freeze it apply the gel and scrub by hand.

Thanks
  Reply
#2
1. Spray the Gum Freeze Spray onto the gum. Wait a couple of seconds for the gum to harden.
2. Then take a blunt scraper tool such as a paint scraper - and chip up the frozen gum. Pick up the gum pieces.
3. Add a small dab of a solvent gel, such as CTI ProSolve gel, or a good citrus gel. Blot the spot with a towel (or paper towels).
Note: I prefer to use paper towels for picking up the gum pieces, and for blotting the solvent gel.

That entire process normally takes less than a minute per piece of gum.

Link to Releasit Gum Freeze Spray...
http://www.excellent-supply.com/Releasit..._p_61.html
  Reply
#3
(04-22-2015, 10:54 PM)encapman Wrote: 1. Spray the Gum Freeze Spray onto the gum. Wait a couple of seconds for the gum to harden.
2. Then take a blunt scraper tool such as a paint scraper - and chip up the frozen gum. Pick up the gum pieces.
3. Add a small dab of a solvent gel, such as CTI ProSolve gel, or a good citrus gel. Blot the spot with a towel (or paper towels).
Note: I prefer to use paper towels for picking up the gum pieces, and for blotting the solvent gel.

That entire process normally takes less than a minute per piece of gum.

Link to Releasit Gum Freeze Spray...
http://www.excellent-supply.com/Releasit..._p_61.html

It works great! Thats exactly how i do it. Did it yesterday morning almost 15 times...
  Reply




Users browsing this thread: 1 Guest(s)