04-21-2017, 11:41 PM
Rich Gallina posted this message earlier. But for some reason there was a glitch in that post which disabled replying to the thread. The glitch is very weird (I think his post might have had a failed attachment). I've deleted his prior post. But here's a copy and paste from that original post...
One of my bearings seized up and literally melted one of my brushes to the plastic piece on the side where you stick the pin for the brush through. The Manual isn't really clear but I need the whole assembly. This piece is accessed when you take the brushes off and has three little screws. I need the cap (stainless steel), the bearing and the Plastic piece that goes inside.
I use this CRB everyday and I need to get these parts out to me quickly. Can someone help me with these parts. If you have a clear image chart it would help me out. Ty
One of my bearings seized up and literally melted one of my brushes to the plastic piece on the side where you stick the pin for the brush through. The Manual isn't really clear but I need the whole assembly. This piece is accessed when you take the brushes off and has three little screws. I need the cap (stainless steel), the bearing and the Plastic piece that goes inside.
I use this CRB everyday and I need to get these parts out to me quickly. Can someone help me with these parts. If you have a clear image chart it would help me out. Ty