09-27-2013, 04:28 PM
(This post was last modified: 09-27-2013, 04:50 PM by OXIGREENGUY.)
I have about 1/2 inch of play between the outside of the spring loaded aluminum mounts and the inside of the wheels. The axle is free floating and slides from side to side during cleaning. You can clearly see the aluminum is transferring onto the steel axle were it's sliding back and forth. Should these areas be lubricated? Will the aluminum "egg" out?
Well........I just got a phone call from ES and they told me about two small set crews on the lower back of the aluminum axle mounts. I'm sure it was in the instructions but I managed to over look it being a dummy.LOL
Thanks so much for the quit call back "Friday evening" !
Well........I just got a phone call from ES and they told me about two small set crews on the lower back of the aluminum axle mounts. I'm sure it was in the instructions but I managed to over look it being a dummy.LOL
Thanks so much for the quit call back "Friday evening" !