03-13-2013, 07:40 PM
yep the sol tank is above the pump, i see what you mean. i will try that tomorrow. after all is said and done i might just remove the entire Sprayborg assembly and use the Orbot sans the Sprayborg...or sell it to someone that can use the Sprayborg. idk if this model Sprayborg will fit onto a new model Orbot though. not sure about keeping or selling yet. since i can't clean resi carpet without dwell time, the Sprayborg is never used.
re: the motor/power box, both great ideas! yep i see where i can punch out a hole and do the side entrance like you said (if there is room inside), i would just have to make sure the cord has clearance from the handle when it goes into the upright position, before punching that hole out.
tx alot F.C.
re: the motor/power box, both great ideas! yep i see where i can punch out a hole and do the side entrance like you said (if there is room inside), i would just have to make sure the cord has clearance from the handle when it goes into the upright position, before punching that hole out.
tx alot F.C.